| Proxim Tsunami.GX 200, full-duplex point-to-point wireless Ethernet bridge |
Proxim Tsunami.GX 200 operates in the unlicensed 5.8 GHz frequency band and exceeds the capacity of two DS-3 leased line circuits. With throughput of 100 Mbps full-duplex IP and 2xT1/E1 interfaces, the Tsunami GX extends its reach over distances of 20 miles or 32 kilometers. Split box design enables flexibility in installation and support. Incorporates advanced diagnostics tools and standards-based management.
Main features:
|
Frequency range |
5725-5850 MHz |
|
Technology |
DSSS, QPSK |
|
Radio Access Method |
FDD |
|
Modulation type |
16 QAM |
|
Payload throughput (maximum) |
about 102 Mbps |
|
Modulated Burst Data Rate |
216 Mbps aggregative |
|
Receiver sensitivity (maximum) |
-73 dBm |
|
Device architecture |
Split-box design (ODU&IDU) |
|
Number of channels (FCC) |
1 (5745 - 5830 MHz) |
|
Antenna |
External |
|
Range with integrated antenna |
N/A |
|
Range with external antenna (maximum) |
20 miles with 6' antenna
14 miles with 4' antenna |
|
Polarization |
Depends on antenna type |
|
Output Power |
19 dBm (adjustable) |
|
Security |
12 character Link ID (48 bits) |
|
Data Communication |
|
Standard Compliance |
IEEE 802.3 CSMA/CD |
|
VLAN pass through |
Yes, 802.1q, maximum packet size 1916 bytes |
|
VPN pass through |
Yes |
|
Layer-2 Traffic Prioritization (QoS) |
NO |
|
Layer-3 Traffic Prioritization (QoS) |
NO |
|
DHCP server option |
NO |
|
Routing, NAT option |
NO |
|
Bandwidth control |
NO |
|
GPS synchronization (self interference avoidance) |
NO |
|
Configuration and Management |
|
Local & Remote Management |
HTTP Web Interface, SNMP, Telnet, Serial Craft Terminal (CLI) |
|
Remote Management Access, SNMP support |
Yes |
|
Interfaces |
|
IF Port Connector |
TNC Female |
|
IF Cable type |
LMR-240 or equivalent for cable lengths <330 feet (or 100 meters)
LMR-400 or equivalent for cable lengths up to 600 feet (or 200 meters)
LMR-600 or equivalent for cable lengths up to 1000 feet (or 300 meters |
|
Impedance |
50 Ohm |
|
Signal |
IF Uplink: 745/750 MHz; IF Downlink: 140 MHz; +48 VDC; Telemetry: 125 KHz; Power: +42 VD |
|
100 Base-FX Ethernet port |
SC-type connector, multimode fiber
100Mbps, full duplex
1300 nm |
|
10/100 Base-TX Ethernet port |
RJ-45 modular jack
Software selectable or auto-negotiate speed and duplex |
|
Configuration Port |
DB-9 DCE (female, 9 pin D sub) RS-232 (8 bit data, No Parity, 1 Stop Bit) |
|
Auxiliary Data Port |
RJ-45 DCE |
|
Alarms Port |
DB-9 (female, 9 pin D sub) |
|
Network Management Port |
2 x RJ-45 (modular jack, unkeyed), 10/100 Base-Tx |
|
VF (Orderwire Bridge) |
RJ-45 jack (4-wire); bridged to Orderwire RJ-11 |
|
Orderwire (for DTMF Phone) |
2-wire, 4-pin mod jack RJ-11 |
|
Wayside E1 Line |
2 x RJ-45 modular jack |
|
Wayside T1 Line |
2 x RJ-48C modular jack |
|
Antenna connector |
Type-N Female |
|
Physical Specifications |
|
Power |
±48 VDC or ±24 VDC IDU: < 30 watts; RFU: <40 watts 240 watts; 50/60 Hz, 110/220 VAC; UL rated Output 20-60 VDC 0.8A DC voltage over coax cable (AC/DC converter is not included) |
|
Environmental requirements |
RF unit -30° to +55° C, 100%, all weather IDU 0° to +50° C, 95% max, non-condensing |
Example of Link Budget calculation with 6' antennas. 20 miles (PDF, 129 KB)
Example of Link Budget calculation with 4' antennas. 14 miles (PDF, 130 KB) Please note, that manufacturer recommended Microwave Point-To-Point Link Calculation software was used for approximate calculations only. This software is not a substitute for a sight survey or a detailed engineering study, and cannot be used as basis for engineering analysis. |