| Axxcelera AB-Full Access, 100/200Mbps+2xT1/E1 Wireless 5.8 GHz Ethernet Bridge |
Axxcelera AB-Full Access, 100/200 Mbps + 2xT1/E1 Point-to-Point Wireless 5.8 GHz Ethernet Bridge
AB-Full Access consists of an Indoor Unit (IDU) and Outdoor Unit (ODU). The AB-Full AccessTM radios are spectrum and data rate scalable enabling service providers or organizations to trade-off system gain with spectral efficiency and channel availability for optimal network connectivity. AB- Full Access delivers aggregate rates up to 200 Mbps within the 5.7 - 5.8 GHz ISM band for distances of up to 20 miles.
Main Features:
|
Frequency range |
5725-5850 MHz |
|
Technology |
OFDM, QPSK, 16-QAM, 32-QAM |
|
Radio Access Method |
FDD |
|
Modulation type |
QPSK, 16-QAM, 32-QAM |
|
Payload throughput (maximum) |
up to 99 Mbps full duplex |
|
Modulated Burst Data Rate |
up to 200 Mbps aggregative |
|
Receiver sensitivity (maximum) |
-81 dBm |
|
Device architecture |
Split-box design (ODU&IDU) |
|
Number of channels (FCC) |
1 channel (5750/5825 MHz)
2 channels (5737/5812, 5762/5837 MHz)
3 channels (5733/5808, 5750/5825, 5766/5841 MHz)
4 channels (5731/5806, 5743/5818, 5756/5831, 5768/5843 MHz) |
|
Antenna |
23 dBi Integrated
External antenna optional |
|
Range with integrated antenna |
5 miles (100 Mbps), up to 7 miles (50 Mbps) |
|
Range with external antenna (maximum) |
19 miles with 6' antenna (100 Mbps); 25 miles (50 Mbps)
15 miles with 4' antenna (100 Mbps); 21 miles (50 Mbps) |
|
Polarization |
Integrated: H-pol or V-pol
External: Depends on antenna type |
|
Output Power |
13-23 dBm Average, 30 dBm Peak |
|
Security |
128-bit key |
|
Data Communication |
|
Standard Compliance |
802.3, 802.3u, MDIX |
|
VLAN pass through |
NO, Max packet size 1518 byte, MTU adjustment required for VLAN pass through |
|
VPN pass through |
NO |
|
Layer-2 Traffic Prioritization (QoS) |
NO |
|
Layer-3 Traffic Prioritization (QoS) |
NO |
|
DHCP server option |
NO |
|
Routing, NAT option |
NO |
|
Bandwidth control |
NO |
|
GPS synchronization (self interference avoidance) |
NO |
|
Configuration and Management |
|
Local & Remote Management |
Proprietary GUI (iConductorTM), SNMP |
|
Remote Management Access, SNMP support |
Yes |
|
Interfaces |
|
IF Port Connector |
N-Type Female |
|
IF Cable type |
LMR-200 or equivalent for cable lengths up to120 feet (or 35 meters)
LMR-300 or equivalent for cable lengths up to 200 feet (or 60 meters)
LMR-400 or equivalent for cable lengths up to 300 feet (or 90 meters)
LMR-600 or equivalent for cable lengths up to 450 feet (or 135 meters)
LMR-900 or equivalent for cable lengths up to 650 feet (or 195 meters) |
|
Impedance |
50 Ohm |
|
Ethernet Port, 100Base-Tx |
RJ-45 Female |
|
Alarms Port |
2 Form C (SPDT), DB9 |
|
Network Management Port |
2 x 10Base-T/100Base-Tx |
|
Wayside T1/E1 Line |
2 x RJ-48C modular jack |
|
Antenna connector |
Type-N Female |
|
Physical Specifications |
|
Environmental requirements |
RF unit -30° to +55° C, 100%; IDU 0° to +55° C, 95% max, non-condensing |
Please note, that manufacturer recommended Microwave Point-To-Point Link Calculation software was used for approximate calculations only. This software is not a substitute for a sight survey or a detailed engineering study, and cannot be used as basis for engineering analysis. |