Easy-to-deploy wireless LAN extension The Tsunami QuickBridge 11 Kit is a highly reliable wireless point-to-point networking solution for any enterprise or small business. Two pre-configured bridges enable users to easily, quickly, and economically install a wireless LAN extension between two locations—eliminating the need for costly leased line or cable alternatives. The kit contains everything you need to establish a point-to-point connection, including one Tsunami MP.11 Base Station Unit, one Tsunami MP.11 Subscriber Unit, surge arrestors, antennas and cables.

Main Features:

Frequency range	2400.0 – 2483.5 MHz
Technology	DSSS
Radio Access Method	CSMA/CA
Modulation type	256 CCK, 16 CCK, DQPSK, DBPSK
Channel bandwidth	22 MHz
Payload throughtput (maximum)	5.4 Mbps
Modulated Burst Data Rate	1, 2, 5.5, 11 Mbps
Receiver s ensitivity (maximum)	-82, -87, -91, -94dBm
Device architecture	Indoor design (IDU)
Number of channels (FCC)	11 (3 non-overlapping)
Antenna	External
Range with integrated antenna	N/A
Range with external antenna (maximum)	13, mi
Polarization	Depends on antenna type
Output Power	15 dBm
Security	128-bit WEP encryption
Data Communication
Standard Compliance	IEEE 802.3 CSMA/CD
VLAN support	Transparent to 802.1q
VPN pass through	YES
Layer-2 Traffic Prioritization (QoS)	NO
Layer-3 Traffic Prioritization (QoS)	NO
DHCP server option	YES
Routing, NAT option	YES
Bandwidth control	YES
GPS synchronization (self interference avoidance)	NO
Configuration and Management
Local & Remote Management	HTTP Web Interface, SNMP, Telnet Command Line Interface (CLI)
Remote Management Access, SNMP support	from wired LAN, wireless Link
Interfaces
IF (intermediate frequency)	N/A
Cable type	Coaxial
IF Frequency	N/A
IF cable Impedance	N/A
Maximum: IF cable attenuation / cable length	N/A
Antenna connector	N-type male
Ethernet	RG45, 10/100BaseT
E1/T1 interface	N/A
Physical specifications
Power	100/240 VAC; 50/60 Hz Output 12V DC 1.5A Active Ethernet (Power over Ethernet) IEEE 802.3af compliant
Enveromental requirements	0–55°C, max 95% rel. humidity (non-condensing)

NOTE: For proper equipment operation line of sight and Fresnel Zone Clearence is required