The EasyBRIDGE 11 seamlessly connects LAN networks across multiple buildings thereby eliminating expensive recurring leased line fees. The result is a carrier quality connection that pays for itself in less than a year, or even sooner with replacing multiple leased lines. Featuring low cost cabling, easy installation, rapid scalability, and seamless integration into existing Ethernet networks, the EasyBRIDGE 11 enables immediate deployment while ensuring maximum cost efficiency. Using Direct Sequence Spread Spectrum technology in the 2.4 GHz license-free band, the EasyBRIDGE 11 is ideally suited for superior building-to-building connectivity in co-located fixed LAN environments. Optimal range (up to 15 miles).

Main features:

Frequency range	2400.0 - 2483.5MHz
Technology	DSSS
Radio Access Method	CSMA/CA
Modulation type	256 CCK, 16 CCK, DQPSK, DBPSK
Channel bandwidth	22MHz
Payload throughtput (maximum)	5.4Mbps
Modulated Burst Data Rate	1, 2, 5.5, 11Mbps
Receiver s ensitivity (maximum)	-93, -90, -90, -87dBm
Device architecture	Split-box design (ODU&IDU)
Number of channels (FCC)	11 (3 non-overlapping)
Antenna	Integrated, 16 dBi, 20є azimuth x 20є elevation
Range with integrated antenna	15, mi (24dBi antemma)
Range with external antenna (maximum)	27, mi (27dBi antemma)
Polarization	Vertical, horizontal
Output Power	18dBm
Security	64 or 128 bit WEP key encryption
Data Communication
Standard Compliance	IEEE 802.3 CSMA/CD
VLAN support	Transparent
VPN pass through	NO
Layer-2 Traffic Prioritization (QoS)	NO
Layer-3 Traffic Prioritization (QoS)	NO
DHCP server option	NO
Routing, NAT option	NO
Bandwidth control	NO
GPS synchronization (self interference avoidance)	NO
Configuration and Management	.
Local & Remote Management	HTTP management application, SNMP, Telnet Command Line Interface (CLI)
Remote Management Access, SNMP support	f rom wired LAN, wireless link
Interfaces
IF (intermediate frequency)	N/A
Cable type	CAT5 (shielded, outdoor)
IF Frequency	N/A
IF cable Impedance	N/A
Maximum: IF cable attenuation / cable length	330, ft
Antenna connector	N/A
Ethernet	RJ45, 10BaseT
E1/T1 interface	NO
Physical specifications	.
Power	100/240 VAC; 50/60 Hz Output 9 VDC 1.3A Propitiatory Power over Ethernet
Enveromental requirements	-40°– 55°C, max 5-95% humidity (non-condensing)

NOTE: For proper equipment operation line of sight and Fresnel Zone Clearence is required