\ RF Accessories, Power Supplies, Towers, Masts \ Lighting Arrestors, Splitters
Email This Page to a Friend
Alvarion Lightning Protector
Winncom PN # ALPU-ALV Manufact PN # ALPU-ALV List Price: Login/Call Login and Stay on this page
The ALPU-ALVR surge suppressor is a high-speed, high-current solid state device designed to protect (1) 55 VDC Ethernet CAT-5 line, (1) 55 VDC LED Signal wire, (1) 55 VDC Reset Wire, and (1) 55 VDC pair. The ALPU-ALVR surge suppressor uses only silicon avalanche suppression diodes (SASD). It connects to the service in a pass through configuration. All input and output connections terminate at two "screw type" terminal blocks. Both the input and output harnesses pass into the suppressor housing via waterproof strain reliefs. The molded plastic enclosure is also waterproof and features integrated mounting holes that are concealed by the cover and integrated gasket as well as a "Membrane Vent" to release any build-up of pressure and moisture due to cable wicking and enclosure heating.
ELECTRICAL SERVICE:    Ethernet Signal Voltage ............................................................................................... 55 VDC Transfer rate .....................................................................................................CAT-5 Configuration..................................................................................................... 2 pair Input Connection ................................................... Screw-Term Block (24-16 AWG) Protection Modes.......................................................... Line to Line, Line to Ground Maximum Continuous Operating Voltage .................................................. 90 VDC VDC Service Voltage ............................................................................................. 55 VDC Configuration........................................................................................... up to 4 wire Input Connection .................................................. Screw-Term. Block (24-16 AWG) Protection Modes.......................................................... Line to Line, Line to Ground Maximum Continuous Operating Voltage .................................................. 90 VDC Reset Wire/LED Signal Wire Service Voltage ............................................................................................. 55 VDC Configuration............................................................................................. 1 wire (ea) Input Connection .................................................... Screw-Term Block (24-16AWG) Protection Mode............................................................ Line to Line, Line to Ground Maximum Continuous Operating Voltage ................................................... 90VDC   ELECTRICAL PERFORMANCE:   3Tested to IEEE/ANSI C62.41 10/1000ms Long Wave Peak Current..............................................................................................150A peak Voltage Protection Level ...............................................130Vpk @ 150A 10/1000ms Tested to IEEE/ANSI C62.41 8/20ms Combination Wave Peak Current............................................................................................1500A peak Voltage Protection Level ...................................................152Vpk @ 1500A 8/20ms Peak Power Dissipation ...............................................................................20,000 Watts Response Time (Max.)...............................................................................5 nanoseconds   ENVIRONMENTAL:    Operating Temperature:............................................................................-40°C to +80°C Storage Temperature: ...............................................................................-40°C to +80°C Relative Humidity:...........................................................................99%(non-condensing)   MECHANICAL/INSTALLATION: Refer to Transtector Installation Instruction document 1200- 148 for further information regarding the installation of this product.   Enclosure dimensions: The suppressor is housed in a molded plastic enclosure that is 6.13 in long, 4.5 in wide and 2.5 in tall. Mounting data: The enclosure mounts with #6 hardware. Wiring data: The ALPU-ALVR surge suppressor is designed to accept (2) multiconductor cables with outside diameters of up to 0.375".