\ RF Accessories, Power Supplies, Towers, Masts \ Lighting Arrestors, Splitters
Email This Page to a Friend
SkyPilot Network Surge Protector For SkyGateway and SkyExtender series
Winncom PN # 620-00705-01 Manufact PN # 620-00705-01 List Price: Login/Call Login and Stay on this page
The SkyPilot Surge Protector provides an effective safeguard against power surges, including lightning strikes and AC voltage spikes. Designed to protect a SkyGateway or SkyExtender using Power over Ethernet (PoE), the Surge Protector protects your investment by preventing circuit damage and eliminating costly downtime.
Parts List: Surge protector box with: Ethernet cable seal Surge protector ground cable 24" CAT-5 shielded Ethernet cable Surge protector mounting bracket Cable tie Crimp lug Accessory guide A Typical Installation: This figure shows a typical tower installation for a SkyPilot SkyGateway/SkyExtender with surge protection. Proper grounding is critical. Verify that the tower is grounded to earth and that the surge protector is grounded to the tower via a tie point on the SkyPilot device. (If the SkyPilot device is on a grounded mast, a ground wire to the mast is not required.) Use shielded, outdoor-rated CAT-5 Ethernet cable to connect the PoE injector to the surge protector. Shielded cable usually provides an additional ground wire (also known as a drain wire) that you can attach to the surge protector’s ground terminal. Never connect a shield to ground at both ends. This creates a ground loop allowing earth current to flow back through the shield, causing noise on the data lines.