The BH Module is a Point-To-Point radio that carries traffic to and from AP Clusters. A set of Point-to-Point BH Modules can also be used as a low latency Ethernet bridge between any two networks or between a network and a single remote computer. In the event no convenient fiber or cable connection is available for IP connectivity to an AP Cluster, a set of BH Modules can be used. Each BH Module communicates to another BH Module using a highly directional antenna. The BH Module operates with a raw data bit rate of 10 Mbps with an approximate throughput of 7+ Mbps and has a maximum range of approximately 35 miles. |
Specifications:
|
Canopy Part Number |
5210BHRFDD |
|
Description |
10 Mbps 5.2 GHz BH - Reflector |
|
Signaling Rate |
10 Mbps |
|
Typical LOS Range |
10 mi (16 km) |
|
Typical Aggregate Useful Throughput |
7.5 Mbps |
|
Frequency range of band |
U-NII 5250-5350 MHz |
|
Non-overlapping Channels |
3 |
|
Channel Width |
20 MHz |
|
Modulation Type |
High Index 2-level Frequency Shift Keying (FSK) optimized for interference rejection |
|
Channel Spacing |
every 5 MHz |
|
Encryption |
DES capable |
|
Latency |
2.5 msec |
|
Carrier to Interference ratio (C/I) |
~3dB @ 10 Mbps, ~10dB @ 20 Mbps at -65dBm |
|
Nominal Receiver Sensitivity (dbm typical) |
-86 dB |
|
Antenna Gain (dB) |
7 dB |
|
Reflector Gain |
18 dB |
|
EIRP (dB) |
30 dB |
|
Equivalent Isotropic Radiated Power (EIRP) |
1.3 W |
|
DC Power (typical) |
0.34 A @ 24 VDC = 8.2 W |
|
Antenna Beam Width |
3 dB antenna beam width 6 degrees, Azimuth and Elevation with Reflector |
|
Mean Time Between Failure (MTBF) |
40 yr |
|
Temperature |
-40° C to +55° C (-40° F to +131° F) |
|
Wind Survival |
190 km/hr (118 miles/hr) |
|
Dimensions |
Module: 11.75 in H x 3.4 in W x 3.4 in D (29.9 cm H x 8.6 cm W x 8.6 cm D). Passive Reflector: 18 inch H x 24 in W (45 cm H x 60 cm W) |
|
Weight |
.45 kg (1 lb), 3.0 kg (6.5 lbs) with passive reflector |
|
Access Method |
Time Division Duplex (TDD) |
|
Interface |
10/100 Base T, half/full duplex. Rate auto negotiated (802.3 compliant) |
|
Protocols Used |
IPV4, UDP, TCP, ICMP, Telnet, HTTP, FTP, SNMP Version 2C |
|
Network Management |
HTTP, TELNET, FTP, SNMP Version 2c |
|
FCC ID |
ABZ89FC5807 |
|
Industry Canada Certification Number |
109W-5210 | |