Motorola Canopy AP Module operates with a raw data rate of 10 Mbps and has a range of approximately ten miles (5.7 GHz SM with reflector). Each AP requires a 24-volt power Configuration Guide source and uses a single 10/100 BaseT Half/Full duplex connection to interface into the CMM or appropriate network connection. |
| Description |
2.4 GHz ETSI Advantage Access Point |
| Canopy Part Number |
2450APWL |
| Market Availability |
Europe |
| Signaling Rate |
20 Mbps Maximum |
| Typical LOS Range |
1 km |
| Typical Aggregate Useful Throughput |
14 Mbps Maximum |
| Frequency range of band |
ISM 2400-2483.5 MHz |
| Non-overlapping Channels |
3 |
| Channel Width |
20 MHz |
| Channel Spacing |
every 2.5 MHz |
| Modulation Type |
High Index 2-level Frequency Shift Keying (FSK) optimized for interference rejection |
| Encryption |
DES Capable |
| Latency |
5 - 7 msec |
| Carrier to Interference ratio (C/I) |
~3dB @ 10 Mbps, ~10dB @ 20 Mbps at -65dBm |
| Nominal Receiver Sensitivity (dbm typical) |
-86 |
| Antenna Gain (dB) |
8 |
| EIRP (dB) |
Adjustable |
| Equivalent Isotropic Radiated Power (EIRP) |
Adjustable from 10 mW to 2.0 W |
| DC Power (typical) |
0.3 A @ 24 VDC = 7.2 W |
| Antenna Beam Width |
3 dB antenna beam width 60 degrees, Azimuth and Elevation |
| Temperature |
-40° C to +55° C (-40° F to +131° F) |
| Wind Survival |
190 km/hr (118 miles/hr) |
| Dimensions |
11.75 in H x 3.4 in W x 3.4 in D (29.9 cm H x 8.6 cm W x 8.6 cm D) |
| Weight |
.45 kg (1 lb) |
| Access Method |
Time Division Duplexing/Time Division Multiple Access (TDD/TDMA) |
| Interface |
10/100 Base T, half/full duplex. Rate auto negotiated (802.3 compliant) |
| Protocols Used |
IPV4, UDP, TCP, ICMP, Telnet, HTTP, FTP, SNMP |
| Network Management |
HTTP, TELNET, FTP, SNMP Version 2c |
| FCC ID |
ABZ89FC5808 |
| Industry Canada Certification Number |
109W-2400 | |